The DJI Phantom 2 Vision+ with remote controller and DJI Vision-equipped smartphone application. The drone's 5200 mAh lithium ion battery pack. In terms of dimensions, the DJI Phantom 2 Vision+ drone can fit inside a cubic foot sans propellers. The plastic propellers themselves are 9.5 inches, but the unit still does not consume a lot of space Offline. 2#. The MAC address is the numbers at the bottom of the QR code on the bottom of the Phantom. When you rebind the range extender to the camera, enter the last 6 numbers of the QR code. 2015-2-7. steve.chalgrave Offline. steve.chalgrave. lvl.1. + Add Friend Person Message. Given its capabilities, the Phantom 2 Vision+ is pretty compact. It measures 13.8 inches from rotor to rotor, and stands about 8 inches tall. The copter itself is white, with LED lights under each What people love about the Phantom 2 are the camera features. The DJI Phantom 2 doesn’t come with a built in camera. But DJI launched its Zenmuse H3-3D 3-axis gimbal in order to carry the GoPro camera. It’s got a gimbal that makes footage to be so stable, like you were filming from the ground. I got a new Phantom 2 with H3-3D gimbal, iOSD mini, and fpv. Got everything mounted and hooked up. I powered up to test the fpv, gimbal, and iOSD and all worked fine. Then I wanted to make sure all firmware was updated before first flight, as many have stated this was imperative to prevent potential fly-always. Firmware seemed to update properly. Then I power cycled and now the gimbal does The Phantom 3 has two cameras. It has one camera for video and one for stabilization. With the Phantom 4, they’ve added three more cameras for improved stabilization and obstacle avoidance. Can you put a 4K camera on Phantom 3 standard? That’s not going to work – it’s just not compatible. The cameras are exactly the same, the only Hi everyone, I bought 2 drones recently, both DJI phantom 2 vision pluses. One is great but the other one needed some work, the camera was not attached and the ribbon cable damaged. I have replaced the cable and attached the camera but when turning on, the camera goes crazy, and all the parts get very warm after a few seconds. I have watched loads of Youtube videos about this and followed #1 My camera is not transmitting to my android phone or iPad. Says connection lost. I have replaced the WiFi module and have preformed binding to the range extender. Still the same message. When I replaced the module, I found the module in the bird had a dent in it, from a bad crash. However, the camera worked on a flight last fall after the crash. Turn on your transmitter and wifi repeater. Turn on your phantom and verify that the camera's power light (on the back of the camera) is on. After everything has been turned on for 15 seconds, on your phone, go to settings and make sure you connect to the phantom network before opening the DJI app. Open the DJI app and go to the camera and it Print this on your bird for future rebinding. Then do the manual bind as per link below. Make sure you press the done button. And keep retrying as it may not work first time. Phantom 2 Vision-Preparing the Range Extender - DJI Wiki. If all else fails then you may have a loose cable or dead wifi module. TxxuhDC.